Casubaris 30PSI Cordless Airbrush Kit,Portable Airbrush with Compressor Set,Auto Start Stop Mini Wireless Rechargeable Air Brush Pump for Makeup Nail Art Painting Cake Decoration Car Tattoo : Arts, Crafts & Sewing

Description

Install the airbrush gun on compressor Press down the trigger to turn on the compressor Press down the trigger to spray air Press down and pull backward the trigger to spray liquid Release trigger to stop spray Release trigger to turn off the compressor in 30s Press the button below to adjust the pressure Pressure I: 20PSI 6-8L/Min Pressure II: 30PSI 8-10.5L/Min Press button for 2 seconds to switch to single action mode. Press button again to switch to double action mode Cleaning And Maintenance Methods: Please test airbrush kit with clear water before using pigment or paint to make sure that the airbrush is not clogged to spray normally. Please use the water-based makeup foundations instead of oil based makeup foundations, you need to use makeup foundations made for airbrush otherwise it will clog the nozzle. It is recommended to use the Professional Airbrush Cosmetic Makeup Foundation. If the airbrush is not able to spray liquid, it may also be that the fluid control knob is too tight, please adjust the tail screw. Or it may be that the nozzle is blocked. Please remove and clean the nozzle. Please refill cup with alcohol or cleaning solvent, then block the needle cover with a finger and spray. The air flows backward into nozzle to clean the paints remained the airbrush. Please repeat it 2-3 times. After that, please wipe off the residual solvent. Dry the airbrush to avoid stains or rust, convenient for next use. If the airbrush compressor can not be charged and does not work. Maybe the battery has been exhausted during use. The battery can not be started and recharged by itself, so the air compressor can only be replaced by us. After continuous use of 25 minutes, the air compressor should be turned off for a few minutes to cool it. After that, the air compressor can be used again and this extends its life. When using acrylic paint, please use water instead of thinner to thin the acrylic paints. The nozzle of this airbrush gun is 0.4mm, so it can only spray watercolor pigments, inks and properly diluted paints. If the paint and liquid are too thick, please properly dilute it with water or thinner.(Note: The concentration of paint and thinner cannot be adjusted higher than milk) After each use of this airbrush, please use clean water or cleaning solvent to clean the fluid cup and the nozzle thoroughly in time and do not let the paint become dry, so as to avoid nozzle clogging or uneven spraying.

Product Overview