STARTO Handheld Digital Oscilloscope Kit 2.4” TFT with BNC-Clip Cable Probe and Power Supply: Industrial & Scientific

Description

See more product details STARTO Digital Handheld Oscilloscope 2.4" TFT Kit with Power Supply and BNC-Clip Cable Probe Q15001 (Assembled Finished Machine) STARTO SQ15001 oscilloscope is an assembled finished machine. NOT DIY PART, it can be used directly to avoid assembling welding process problems and greatly saves the assembly time. The sensitivity has been extended in both directions in width and height, which is wider and higher than others. It reaches 5mV/div -- 20V/div, while others is only 10mV / div - 5v / div. It has been added the rotary encoder, makes parameter adjustment more quicker and easier For this updated digital oscilloscope, includes a 9V power adapter, so you can use it by plug it in directly, so convenience that you don't need to place another order for the power adapter. Detailed Operation instructions, troubleshooting guide and schematic are also provided. Specification: Number of Channel: 1 Analog Bandwidth: 0 - 200KHz Sensitivity: 5mV/Div - 20V/Div Sensitivity error: < 5% Resolution: 12-bit Input Impedance: 1M ohm Maximum Input voltage: 50Vpk Coupling: DC, AC, GND Trigger Modes: Auto, Normal, Single Trigger Types: Rising/falling edge Trigger Position: 1/2 of buffer size fixed Display: 2.4 inch color TFT LCD with 320 x 240 resolution Power Supply: 9V DC (8 - 10V acceptable), NOT INCLUDED Dimension: 115mm X 75mm X 22mm Weight: 100 gram (not including cables and power supply) Package Contents: Oscilloscope * 1 BNC-clip cable * 1 Users Manual * 1 Kindly note: Runs on 9V (do not use power voltage higher than 10V!) Before mouting any parts to the main board connect a 9V power supply (center positive) to J7 on the board to check the display. You should see the scope boots up to a screen similar to D1(LED) blinks twice. Basic Button Functions [V/DIV]: Select sensitivity or vertical position,The selected parameter indicator will be highlighted. [SEC/DIV]: Select timebase or horizontal position. The selected parameter indicator will be highlighted. [TRIGGER]: Select trigger mode, trigger level, and trigger edge. The selected parameter indicator will be highlighted. [OK]: Enter HOLD state (freeze waveform). Pros it again will de-freeze. [ADJ]: Adjust the parameter selected (highlighted). Short press toggles Fast Adjustment mode. Couple switch: Set couple to DC, AC, or GND. When GND is selected the scope input is isolated from input signal and connected to ground (0V input).

Product Overview