5 GAL Armor AR350 Solvent Based Acrylic Wet Look Concrete Sealer and Paver Sealer - -

Description

The Armor AR350 is a solvent based acrylic wet look sealer that is designed to seal, enhance, and protect a variety of interior and exterior concrete and concrete paver surfaces. The Armor AR350 penetrates deep into the surface where it chemically bonds to the pores of the concrete and pavers, creating a long lasting, non-yellowing, breathable finish that enhances dull or faded surfaces by creating a darkened wet look, and low gloss finish. Benefits: Made from non-recycled US manufactured resins Breathable, low VOC Can be applied with a roller or sprayer Non-yellowing and UV resistant Will reduce concrete dusting and deterioration caused by surface abrasion Offers resistance to water, stains, some chemicals, and salt damage Offers superior adhesion to a variety of concrete and paver surfaces Will bring out the color in dull or faded concrete and pavers by darkening them to give them a "wet look" Offers a durable low gloss finish Self-priming, easy recoat and low maintenance When properly applied can last up to 2-5 years before the need for a recoat Can be applied to unsealed surfaces, or surfaces previously sealed with a solvent based acrylic Appearance When applied in clear, the Armor AR350 will darken the surface to bring out the natural coloring the concrete or pavers, and seal it with a transparent low gloss finish. The actual level of gloss and enhancement received will depend on the type and age of the surface, age, porosity, condition, applicator, application method, and amount of material applied. For an accurate representation of what your surface will look like once sealed, we suggest applying the product to a test area first. The Armor AR350 is designed for use on poured concrete, stamped concrete, aggregate concrete, and concrete paver surfaces. Do not apply this product to red clay brick, slate, flagstone, or other types of natural stone. If you are looking to seal red clay brick, slate, flagstone, or any other type of natural stone, consider instead the Armor WL550 or the Armor SX5000 WB. The Armor AR350 is a fantastic sealer for poured concrete, stamped concrete, aggregate concrete, and concrete paver surfaces. It can be applied to unsealed surfaces as well as surfaces previously sealed with a solvent based acrylic. Coverage: One gallon of the Armor AR350 will cover up to 175 square feet per coat. Two coats are recommended to achieve the maximum life and performance benefits. Coverage can vary depending on the porosity of substrate and the application method. How to Apply: First, make sure that the surface is clean and free of any contaminants that could prevent proper penetration or adhesion. If the surface was wet, allow at least 24 hours to dry. In the early evening (5 PM or later), when the surface has had time to cool down from exposure to the sun, apply the first coat using a 3/8" nap roller or solvent-resistant HVLP sprayer. Wait 24 hours and repeat with a second coat. Allow the surface 48 to dry before introducing it to water, foot, or vehicle traffic. Will the surface be slippery when wet? Yes, the surface may be slippery when wet because the sealer prevents water from absorbing into the surface. Foundation Armor manufactures a fine non-slip additive and a coarse non-slip additive that can easily be mixed into the sealer before applying. How long does the sealer last? The Armor AR350 can last up to 2-5 years before the need to reseal. Surface porosity, environment, surface abrasion, and the amount of material applied will ultimately determine the life of the sealer. Typically, exterior substrates are sealed every 1-3 years and interior substrates are sealed every 3-7 years. Is the Armor AR350 breathable? Yes, the Armor AR350 is a breathable acrylic sealer. Is the Armor AR350 UV stable? Yes, the Armor AR350 is UV stable and will not yellow from exposure to UV rays. What if I want a high gloss? If you want a high gloss consider the Armor AR500 instead.

Product Overview